Installation Instructions Chapter 4

FibeAir 1500 Installation & Operation Manual Chapter 4. System Setup
4-2 The Setup Procedure Revision 2.0
4.2.1. System Setup
To start the FibeAir 1500 radio link configuration you first need to setup the
Ethernet and PPP/SLIP IP addresses. Once you have defined these
addresses, you will be able to configure the system using the GiganetView
software.
To set the addresses, perform the following operations:
1. Connect the RS-232 port of your computer to the RS-232 (9-PIN) port
on the indoor unit front panel. This port is labeled “Terminal” and is
located near the front panel LEDs.
2. Connect to the standard Windows HyperTerminal at 19,200 bits per
second.
3. After you are connected, press Enter. The login menu appears.
Figure 4-1 FibeAir 1500 Terminal - Login Screen
4. Type giganet as the password. The main menu displays.
Figure 4-2 FibeAir 1500 Terminal - Main Configuration Menu