Installation Instructions Chapter 4

FibeAir 1500 Installation & Operation Manual Chapter 4. System Setup
4-16 Connecting to the IDU - Gigaview Revision 2.0
9. Select Server tab and chose PPP or SLIP as your Dial-up server
type. Verify that the protocol (PPP or SLIP) and is in accordance to
the serial configuration that was set on the Hyper Terminal.
10. Check only TCP/IP then Click TCP/IP Settings.
11. Select Specify IP Address and enter address on the same sub-net
as the serial address of the IDU.
12. Make sure that Server assigned name server addresses is
selected and Use IP header compression and Use default
gateway on remote network are unchecked.
13. Whenever you wish to connect to the IDU, double-click Dial-Up
Networking and select the number you wish to dial at the
Phonebook Entry.
14. To verify connectivity, ping the IDU’s Ethernet IP address and make
sure you have a reply: Select Start Í Run and open ping
IP
address
.
Once communication is established, run the GiganetView management
application.