User's Manual Part 9
The type tower mount is an offset 3-point suspension unit
which has been designed to mount a 4ft (1.2m) or 6ft (1.8m)
parabolic antenna to a 4-1/2in (115mm) diameter pipe.
The mount incorporates an eyebolt which, by pivoting the
reflector about two hinges, provides an elevation adjust-
ment of ±5 degrees. Azimuth adjustment is obtained by
means of an adjustable strut (see Figure 1).
Mount Frame rotated
180 deg.
Red Tape and Reflector to
remain at same orientation
Red Tape marking
Strut arrangement
The installation, maintenance or removal of antenna
systems requires qualified, experienced personnel.
These installation instructions have been written for
such personnel. Antenna systems should be inspected
once a year by qualified personnel to verify proper
installation, maintenance and condition of equipment.
Ceragondisclaims any liability or responsibility for the
results of improper or unsafe installation practices.
READ THE INSTRUCTIONS THOROUGHLY
BEFORE ASSEMBLY
Ceragon Tower Mount Options
!"##$