User's Manual Part 9

4(9)
4. Assembly of the shroud and the planar radome (only SU-and SD-Types)
* for spots free of paint 90 deg from TOP (left and right) add 2 serrated lock washers A6.4
• The rim of the reflector must be clean and dry
• Stick on the RF gasket tape 360 deg in a way, that
 all mounting holes are covered by the tape and
 the wire mesh is directed to the center of reflector
• position the shroud -clean and dry- on inside of the reflector.
antenna offset to the left
TOP shroud to TOP reflector
or
antenna offset to the right
TOP shroud oposite to TOP reflector
TOP planar radome
12 screws M6 x 20
24 washers 6.4
∅
18mm
12 sl nuts M6
TOP
Offset to the left
RF gasket tape, self adhesive
∅
6 mm punched
after positioning of
the shroud
wire mesh towards
center of reflector
reflector, complete with casting mount
12 screws M6 x 25
24 washers 6.4
∅
18mm*
12 sl nuts M6
TOP
Offset to the right