User's Manual Part 9

2
4
Antenna top
Red tape: indicates
top of antenna.
Absorber clip (typ.)
Insert hole plugs (6) in
top and side drain holes.
Bottom drain holes
must remain open.
Insert the tapered pin (9) into the reflector
hole as shown. Pry the shield slightly to
align shield and reflector holes to receive
a bolt. Repeat at 3 opposite positions.
Insert shield into
reflector so that
mounting holes align
with rim holes
in reflector.
Position absorber segments
at sides of half-absorber antennas.
Drain hole plug
Assembled shield
arrangement
Reflector mounting
hole
3
Antenna shield
arrangement
Threaded insert for
radome attachment
3
2
1
Drain holes: align
with antenna top.
Full-absorber antenna
shield version shown
Position of red
tape
9
Reflector
Shield
assembly
Reflector
1
Fit loosely with
lockwasher (2)
and nut (3) in 4
opposite places
as shown then
tighten.
2
3
Half Absorber
0.5"/1.0" Absorber
0.5" Absorber
1.0" Absorber