User's Manual Part 9

 Hardware Check. Recheck all hardware to en-

sure that it has been correctly tightened during installation

procedure.

 Corrosion Prevention. Paint the cut end of the

strut with a Zinc based paint (eg. 'Galvafroid') to prevent

corrosion.

Figure 9. Azimuth Strut Positioning

Azimuth Adjustment Strut

Figure 8. Attachment of Side Struts to Round

Tower Members

Clamp Attachment to Round Tower

Member (48 to 76mm Dia)

Invert Clamp for Round

Members (25 to 47mm Dia)

Strut may be attached to a Round Tower Mem-

ber of 25 to 76mm Diameter using Pipe Clamp

Assembly Part No. 33984-7. This Must be or-

dered separately