User manual

16
Please note that the brackets “<“ and “>“in the following commands are not part of the commands but
are included in order to increase the readability of the overview!
 Four additional alarm numbers (mobile phones) can be defined using C2: - C5: commands. These
numbers are allowed to set relay 1 by a call and they are informed vian SMS in case of Start-up or
events. These numbers are not allowed to send configuration SMS messages unless they include the
password in the SMS.
 If an alarm number is given in international format, the number must start with ‘+’. (e.g.
[phone])
 With the command “PN:<4digit password>.” the password can be changed. The password can
include letters and figures but special characters are not allowed. All letters have to be in capital.
 The texts of the event or start-up SMS can be changed with the commands “E1:<text1>.”,
“E2:<text2>.”… and “PT:<startup text>.”. The message length must not exceed 64 characters. Do not
use command syntax inside a message text. The ‘.’ is the terminating character of the text. Each new
text must be sent in a separate SMS.
 You can generate an extended clip list of 1000 clip numbers. The numbers stored in the clip list are
allowed to switch relay 1 with a phone call. Use “CL:” to generate the clip list and add further phone
numbers. With “CD:” you can delete a phone number from the list. Be aware that you cannot read
out the clip list (getting SMS messages) because it could by far exceed the size limitation of SMS
texts.
 With the command “TOx:<text>.” (x = 1 to 10, see command list above) an E-Mail address for the
particular events is configured. 5 E-Mail Adresses can be configured, divided by <;>.
The maximum length of the particular E-Mail addresses is 25 signs.
 With the command “SUBx:<text>.” (x=1 to 10, see command list above) the subject of the particular
E-Mails is configured. The maximum number of sings for the subject is 128 signs. The predefined
text is: “STD32 Event x”.
 The content of the E-Mail is configured with “BODY:<text>.”. The maximum length is 143 signs.
 The E-Mail sender address (of the STD32) is changed with “FROM:<text>.”. The maximum length is
25 signs.
Please note that all commands listed in the section “Configuration SMS” require the 4-digit keyword at
the beginning.
6.5 Examples of SMS Commands
In the following examples, each command is preceded by a 4-digit password. Here, the password is set
to the value "9851", but it must be replaced with your unique password.
Task
SMS Command Sequence
Start-up alarm off, relay 1 on, relay 2 off, time
of activation of input 1: 5 sec
9851 S:0.O1ON.O2OFF.I1:5.
Switching time of relay 1 = 90 seconds
9851 O1:90.
Reset settings to factory settings
9851 R:
Configuration of the second alarm number
9851 C2:[phone].
Deleting a alarm number
9851 C2:"".
Configuration of a new password
9851 PN:AB12.
Adding a new clip to the extended clip list
9851 CL:[phone].