User manual

6 SMS Commands
There is a wide range of special commands which can be used to configure the device, request
information or to trigger certain actions. All the commands are designed to be easy to enter even when
using a standard phone. This chapter describes all the commands the device will understand and how
to use them. The format of the SMS commands is explained in Section 6.3.
6.1 Overview of SMS Commands
Configuration Commands
R:
reset default factory settings
ST?
request device status SMS
S:
1 - enable startup SMS
0 - disable startup SMS
C2:
set phone number nr 2
C3:
set phone number nr 3
C4:
set phone number nr 4
C5:
set phone number nr 5
PN:
set different password (max 4)
E1:
set message text for INPUT 1 event (max 64)
E2:
set message text for INPUT 2 event (max 64)
PT:
set message text for POWER-UP event (max 64)
M1:
Set the phone number of the Administrator Phone
Example: xxxx M1:[phone] (xxxx is the device’s password)
Table 2: Configuration Commands
Inputs & Outputs commands
O1ON
turn relay 1 on
O1OFF
turn relay 1 off
O2ON
turn relay 2 on
O2OFF
turn relay 2 off
O1:xxxxx
defines time period for relay 1 action (in seconds) 0 = infinite
O2:xxxxx
defines time period for relay 2 action (in seconds) 0 = infinite
A1:xxxxx
defines delay for relay 1 reply (in seconds) 0 = no message
A2:xxxxx
defines delay for relay 2 reply (in seconds) 0 = no message
I1:xxx
debounce time for input 1 (in seconds)