User manual

2
Important information
This technical description contains important information for start up and use of the HT910 E Terminal.
Read it carefully before you start working with the HT910 E Terminal.
The warranty will be void should damage occur due to non-compliance with these instructions for use.
We cannot accept any responsibility for consequential loss.
We cannot be held responsible for material loss or personal injury that is due to incompetent use or
non-compliance with the safety instructions. The warranty will be void in such circumstances.
The HT910 E Terminal contains highly integrated components which can be damaged by electrostatic
discharge if the user would open the housing.
CEP preserves the right to change the included information without notice and doesn’t take
responsibility for errors in the document and/or missing information.
Therefore only touch the HT910 E Terminal on the housing or connectors and avoid
touching the components on the board.
Safety Instructions
When using products which are exposed to electric voltage the valid regulations have to
be observed.
Before opening of a device always pull the mains adapter or make sure that the device is disconnected
from the power supply.
You should only use tools on components, modules or devices if they are disconnected from the power
supply and the electric charge, which may still be stored in some components, inside the device has
been discharged.
All cables and wires which are energized and connected to the device, the module or components have
to be checked regularly for any damage of the isolation shield or fractures of the cables. If the supply
cables are visibly damaged the device has to be taken out of operation immediately until the faulty
cable has been exchanged.
When using components or modules it is necessary to strictly observe the specification given in the
corresponding description of these components. If a description for a private end-customer not clearly
states which electric data is valid for a component or a module, how to wire the device, which external
components or additional devices can be connected or which parameters these components are
allowed to have, a specialist must be contacted.