User manual

Please observe the maximum output voltage of the relays and the maximum input
voltage of the inputs! (Refer to Section 2 Operating Conditions).
Status LEDs:
The STD35 has several LEDs that indicate the operating status:
 L1 (Green): status of the power supply. It flashes in green when the external power is applied to the
device.
 L2 (Yellow): GSM status. This LED flashes once every 2 seconds for a short moment when the device
is logged into the GSM network.
 L3 (Yellow): GSM status: The LED flashes faster during a DOTA Update.
 L3 (Red): General Status LED. Cyclic flashing 1x every 2 seconds: the device is ready for use.L4
(Green): General Status LED This indicates whether an administrative telephone number is
configured or not (see section 5.1 General preparations.
An alternate flashing of the LEDs L3 and L4 indicates that the device has not yet been configured.
Button:
A hardware reset of the device is performed if the switch is pressed for more than 7 seconds.
5 Quick Start Up
The following section provides step by step instructions to get the STD35 up-and-running without
extensive setup.
5.1 General preparations
You need an activated SIM card of a GSM network provider. The PIN of this card has to be set to “0000”
(4 times zero). As an alternative, you could use the PIN “2468”. To change the PIN you can use a regular
mobile phone. Please refer to your mobile phone manufacturer’s user manual for instructions on how
to change the PIN.
If you use a SIM card with a PIN different from “0000” or “2468” in the STD35, the
STD35 will use a “wrong” PIN. After the second attempt to power up the device
your SIM card will be blocked. In this case you need to use the “Super-PIN” or
“PUK” to assign a new PIN to your card. Please look into the user guide of your
mobile phone. There you find how to use the PUK to de-block the SIM card.
You can also use a SIM card without a configured PIN.
In the following we refer to the “Master Mobile” as the mobile telephone which you want to use to
switch the outputs and to configure the STD35 via calls.
The “incognito” or “private call” function of the mobile must be deactivated in order to be able to
administer the STD35. In other words, the Master Mobile has to transmit the mobile phone number
with every call. Please refer to the user guide of your mobile telephone to change this setting.
To test the setting you can call a different mobile phone; there your phone number or name should be
displayed.