User's Manual
Table Of Contents
- Contents
- 1 Warning - and Safety instructions
- 2 Abbreviations and Terms
- 3 Scope of delivery
- 4 Labeling of the product
- 5 Product description
- 6 Preparing the Product for Use
- 7 Operating Instruction
- 7.1 Change of the battery
- 7.2 Connect the CT-MultiPTT Bluetooth to the radio
- 7.7 Telephone mode (mode 1)
- 7.8 Telephone mode with MIC switch (mode 2)
- 7.9 Limited telephone mode with MIC switch (mode 3)
- 7.10 Increase the volume
- 7.11 Lower the volume
- 7.12 Battery status
- 7.13 Change the PIN for CT-Multi PTT Bluetooth
- 7.14 CT-Wireless-PTT (optional)
- 7.15 Subscribe the CT-Wireless-PTT to the CT-Multi PTT Bluetooth
- 7.16 Delete one CT-Wireless-PTT from the memory of the CT-Bluetooth Adapter
- 7.17 Delete all CT-Wireless-PTT from the memory of the CT-Bluetooth Adapter
- 7.18 Switch-on and operation
- 7.19 End of operation
- 8 Safekeeping – storage
- 9 Disposal
- 10 Technical data
- 11 Brief instruction
Revision: 02/1015 DOK 1643-us 8 of 28
Figure 3
a Plug for connection to a radio
b Pasted label with name of device
c Socket for communication set
d Battery compartment
e PTT button
f Bluetooth control button + storage battery / battery pilot lamp
Green, continuous - battery fully charged
Green, flashing - battery at half charge
Red, flashing - battery almost flat, approx. 30 minutes remaining
LED off - device does not switch on, battery/storage battery is flat
g Volume-up key (in active call – telephone louder)
h Volume-down key (in active call – telephone softer)
I CT-Wireless PTT
a
b
d
e
f
g
h
i
c