User's Manual
Table Of Contents
- Contents
- 1 Warning - and Safety instructions
- 2 Abbreviations and Terms
- 3 Scope of delivery
- 4 Labeling of the product
- 5 Product description
- 6 Preparing the Product for Use
- 7 Operating Instruction
- 7.1 Change of the battery
- 7.2 Connect the CT-MultiPTT Bluetooth to the radio
- 7.7 Telephone mode (mode 1)
- 7.8 Telephone mode with MIC switch (mode 2)
- 7.9 Limited telephone mode with MIC switch (mode 3)
- 7.10 Increase the volume
- 7.11 Lower the volume
- 7.12 Battery status
- 7.13 Change the PIN for CT-Multi PTT Bluetooth
- 7.14 CT-Wireless-PTT (optional)
- 7.15 Subscribe the CT-Wireless-PTT to the CT-Multi PTT Bluetooth
- 7.16 Delete one CT-Wireless-PTT from the memory of the CT-Bluetooth Adapter
- 7.17 Delete all CT-Wireless-PTT from the memory of the CT-Bluetooth Adapter
- 7.18 Switch-on and operation
- 7.19 End of operation
- 8 Safekeeping – storage
- 9 Disposal
- 10 Technical data
- 11 Brief instruction
Revision: 02/1015 DOK 1643-us 25 of 28
Should the radio be turned off (battery change) while the Bluetooth module is on,
you hear in the communication set for 30 seconds an acoustic warning signal in
two (2) second intervals. During these 30 seconds press a key or turn the radio on,
to ensure the Bluetooth module continues in switched-on condition. This way it is
possible to keep up telephone standby.
Switch off the Bluetooth module
Turning the radio off, switches the Bluetooth module off as well, with a delay of 30 seconds. However,
you are also able to disconnect the entire system, independently from the radio.
Press simultaneously both, the Bluetooth and Volume-up keys, for about 3 seconds until you hear a
descending
three-tone sequence in the communication set which confirms the switch-off. The LED
in the Bluetooth key does not glow anymore. Let the keys go.
7.19 End of operation
To end the operation, turn the radio off.
In some radios, the accessory interface continues energized, even after turning the
radio off. In such a case switch the key off manually, or disconnect the CTMultiPTT
Bluetooth plug from the radio adapter. Otherwise, it is possible that the CT-
MultiPTT Bluetooth storage battery is discharging.
8 Safekeeping – storage
Store the cleaned devices in a clean, dry place at normal room temperature and in normal relative air
humidity.
Product damage!
Do not store CeoTronics products outside or in damp ambient conditions. At all
times keep them clean, dry and at normal air humidity. CeoTronics products must
not be stored in areas with a temperature of over +80° C (+176° F), e.g. in the
summertime on the parcel shelf of a car. If not stated otherwise, the following
temperature ranges are admissible for CeoTronics products: -10 to +55°C for
operation, storage -40 to +80°C.