User's Manual

Revision: 02/1015 DOK 1643-us 23 of 28
7.17 Delete all CT-Wireless-PTT from the memory of the CT-Bluetooth Adapter
1. Switch the CT-Multi PTT Bluetooth off, if it is on.
2. Press all three (3) lateral keys of the CT-Multi PTT
Bluetooth simultaneously until the LED in the
Bluetooth button starts flashing three (3) times red-
green. The LED keeps flashing red-green until you
let the buttons go, however minimum three times.
3. Press the Bluetooth key of the CT-Multi PTT
Bluetooth and hold it down for at least two (2)
seconds. Now the deletion mode is active.
- in deletion mode the LED flashes very quickly
To abort the deletion mode, press the Bluetooth key
briefly once again.
4. Now, press the Bluetooth key again for more than
two (2) seconds. If the LED glows four (4) seconds,
all transmitter codes are deleted.
5. Then, press the Bluetooth key of the CT-Multi PTT
Bluetooth one time. The LED is not glowing
anymore. Now you can change to operating mode
(6.) or apply (3. and ff.) of 7.15 / 7.16 / 7.17.
6. Change to operating mode of the CT-Multi PTT
Bluetooth by pressing for at least one (1) second
both, the Volume-up” and “Volume-down” keys like
changing operating modes.
Figure 27
Bluetooth
key
Volume-up
key
Volume-down
key