User's Manual
Table Of Contents
- Contents
- 1 Warning - and Safety instructions
- 2 Abbreviations and Terms
- 3 Scope of delivery
- 4 Labeling of the product
- 5 Product description
- 6 Preparing the Product for Use
- 7 Operating Instruction
- 7.1 Change of the battery
- 7.2 Connect the CT-MultiPTT Bluetooth to the radio
- 7.7 Telephone mode (mode 1)
- 7.8 Telephone mode with MIC switch (mode 2)
- 7.9 Limited telephone mode with MIC switch (mode 3)
- 7.10 Increase the volume
- 7.11 Lower the volume
- 7.12 Battery status
- 7.13 Change the PIN for CT-Multi PTT Bluetooth
- 7.14 CT-Wireless-PTT (optional)
- 7.15 Subscribe the CT-Wireless-PTT to the CT-Multi PTT Bluetooth
- 7.16 Delete one CT-Wireless-PTT from the memory of the CT-Bluetooth Adapter
- 7.17 Delete all CT-Wireless-PTT from the memory of the CT-Bluetooth Adapter
- 7.18 Switch-on and operation
- 7.19 End of operation
- 8 Safekeeping – storage
- 9 Disposal
- 10 Technical data
- 11 Brief instruction
Revision: 02/1015 DOK 1643-us 21 of 28
7.15 Subscribe the CT-Wireless-PTT to the CT-Multi PTT Bluetooth
1. Switch the CT-Multi PTT Bluetooth off, if it is
on.
2. Press all three (3) lateral keys of the CT-Multi
PTT Bluetooth simultaneously until the LED of
the Bluetooth button starts flashing three (3)
times red-green. The LED keeps flashing red-
green until you let the keys go, however
minimum three times.
3. Press the Bluetooth key three (3) times until
the LED flashes as follows:
….red-red-red…..red-red-red….red-red-red….
4. Press briefly the CT-Wireless-PTT (the red
LED glows); simultaneously and as
confirmation the LED in the Bluetooth key
lights up red for about four seconds; now, the
CT Wireless-PTT is subscribed.
5. Press now one time the Bluetooth key of the
CT-Multi PTT Bluetooth. The LED does not
glow anymore. Now you can change to
operating mode (6.) or apply (3. and ff.) of 7.15
/ 7.16 / 7.17.
6. Change to the operating mode of the CT-Multi
PTT Bluetooth by pressing for at least one (1)
second both, the Volume-up” and “Volume-
down” keys – like changing operating modes.
Figure 25
In case the CT-Multi PTT Bluetooth is in programming mode, all other functions
are disconnected. In order to exit programming mode and enter operating mode,
press for at least one (1) second both keys, “Volume-up” and “Volume-down”.
We recommend, after the loss of a CT-Wireless-PTT, to delete it from the receiver.
For it, it is necessary to delete all CT-Wireless-PTT from the CT-Multi PTT
Bluetooth (see 7.17
), and to re-subscribe the existing ones.
The CT-Multi PTT Bluetooth accepts the subscription of maximum 32 CT-
Wireless-PTT devices.
Bluetooth-
key
Volume-up
key
Volume-down
key