User's Manual
Table Of Contents
- Contents
- 1 Warning - and Safety instructions
- 2 Abbreviations and Terms
- 3 Scope of delivery
- 4 Labeling of the product
- 5 Product description
- 6 Preparing the Product for Use
- 7 Operating Instruction
- 7.1 Change of the battery
- 7.2 Connect the CT-MultiPTT Bluetooth to the radio
- 7.7 Telephone mode (mode 1)
- 7.8 Telephone mode with MIC switch (mode 2)
- 7.9 Limited telephone mode with MIC switch (mode 3)
- 7.10 Increase the volume
- 7.11 Lower the volume
- 7.12 Battery status
- 7.13 Change the PIN for CT-Multi PTT Bluetooth
- 7.14 CT-Wireless-PTT (optional)
- 7.15 Subscribe the CT-Wireless-PTT to the CT-Multi PTT Bluetooth
- 7.16 Delete one CT-Wireless-PTT from the memory of the CT-Bluetooth Adapter
- 7.17 Delete all CT-Wireless-PTT from the memory of the CT-Bluetooth Adapter
- 7.18 Switch-on and operation
- 7.19 End of operation
- 8 Safekeeping – storage
- 9 Disposal
- 10 Technical data
- 11 Brief instruction
Revision: 02/1015 DOK 1643-us 14 of 28
7.1.2 Change of the battery in the CT-Wireless-PTT
1. Open the battery compartment at the back of
the CT-Wireless-PTT with help of the special
tool by short turn to left.
Figure 15
2. Remove the circuit board careful from the
housing. Change the battery and pay
attention to the correct position; the lettering
must be visible.
Use only the 3 V batteries type CR2032.
Pay attention to the correct polarity.
Do not throw used (defective) storage batteries
into the domestic refuse.
Figure 16
3. When closing the CT-Wireless-PTT insert, if
needed, a new gasket under the cover edge.
Put the hooks of the cover in the rail of the
housing and close the cover with a twist to
the right. Pay attention that the cover fits tight
with the housing.
Figure 17
Touch-lamina
Circuit board
Sealing ring
Lid