User's Manual
Table Of Contents
- Contents
- 1 Warning - and Safety instructions
- 2 Abbreviations and Terms
- 3 Scope of delivery
- 4 Labeling of the product
- 5 Product description
- 6 Preparing the Product for Use
- 7 Operating Instruction
- 7.1 Change of the battery
- 7.2 Connect the CT-MultiPTT Bluetooth to the radio
- 7.7 Telephone mode (mode 1)
- 7.8 Telephone mode with MIC switch (mode 2)
- 7.9 Limited telephone mode with MIC switch (mode 3)
- 7.10 Increase the volume
- 7.11 Lower the volume
- 7.12 Battery status
- 7.13 Change the PIN for CT-Multi PTT Bluetooth
- 7.14 CT-Wireless-PTT (optional)
- 7.15 Subscribe the CT-Wireless-PTT to the CT-Multi PTT Bluetooth
- 7.16 Delete one CT-Wireless-PTT from the memory of the CT-Bluetooth Adapter
- 7.17 Delete all CT-Wireless-PTT from the memory of the CT-Bluetooth Adapter
- 7.18 Switch-on and operation
- 7.19 End of operation
- 8 Safekeeping – storage
- 9 Disposal
- 10 Technical data
- 11 Brief instruction
Revision: 02/1015 DOK 1643-us 10 of 28
5.3 CT-Multi-PTT Bluetooth with CT-ClipCom Digital
The CT-Multi-PTT Bluetooth is also available with integrated CT-ClipCom Digital technology and firmly
attached communication set.
The following two (2) system configurations are available:
CT-ClipCom Digital EarMike consisting of an ear microphone and an additional speaker
You hear radio messages and the ringing tone of the cellular phone on both sides. If a PTT transmit
button is activated or a conversation takes place via cellular phone, the RH ear microphone is switched
over from speaker to microphone operation. This deactivates the reception of exterior noise on that ear
microphone.
CT-ClipCom Digital BoomMike consisting of one earphone with boom microphone and an additional
speaker.
While activating a transmit button, the reception of exterior noise continues being active on both sides.
The earmike is an electroacoustic transducer working as both, microphone (transmitting) and earphone
(receiving), and is worn inside the ear with earplugs or personalized ear molds. Regarding personalized
ear molds, follow the instruction manual Dok1463.
Figure 7
5.3.1 EarMike
The ear microphone is on the right side, marked in red ink. The earphone is on the left side, marked in
blue ink. The ear microphone housing contains, in addition to the ear microphone (Figure 8/c) itself,
also the ASR microphone (Figure 8/d)
CT-ClipCom Digital
BoomMike
Earmike
Earphone