Integration Manual

Integration Manual

revision:

date:

author:

02.10.20

Seite 1 von 3

Integration Manual

FCC-Compliance

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions;

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause

undesired operation.

Any changes or modifications NOT expressly APPROVED by CeoTronics AG could void the

user's authority to operate the equipment.

This RF Module is approved with the two onboard Inverse-F-type PCB antennas

(W200, W201).

The optional antenna connectors (X201, X202) are not functional/mounted.

Limitation: The RF Module is currently approved for integration into fixed and mobile categorized end

products. The usage inside portable host devices and/or simultaneous transmission with any other

transmitter requires additional compliance tests and procedures.

Furthermore the RF parameters of this CT-DECT Module M7 have to be evaluated in the final end

product according to FCC KDB 996360 D04 to check for emissions that may occur due to

intermixing of emissions with other transmitters, digital circuitry or due to physical properties of the

host product (enclosure). Hereby the levels of the fundamental and worst case unwanted/spurious

emissions based on the original test report of the stand-alone module shall be repeated.

The regulatory compliance of the CT-DECT Module M7 does not exempt the end product from being

evaluated against applicable regulatory demands; for example, FCC Part 15B criteria for

unintentional radiators including appropriate equipment authorization (typically SDoC).

Any notification to the end user about how to install or remove the integrated radio module is

NOT allowed.

PAGE 1
Integration Manual Integration Manual FCC-Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions; 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications NOT expressly APPROVED by CeoTronics AG could void the user's authority to operate the equipment.
PAGE 2
Integration Manual End-product labeling requirements FCC-Compliance End products that have this CT-DECT Module M7 integrated must have a label containing at least the information shown below: Contains: FCC ID: L52CT-M7CEO1 The label must be affixed on an exterior surface of the end product such that it will be visible upon inspection. In accordance with 47 CFR § 15.
PAGE 3
Integration Manual End-product user manual instructions (Statements to be added inside the user manual of the end products equipped with the CT-DECT Module M7) FCC Compliance This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.