User's Manual

4
Important Information for Users of the
CT-DECT transceivers
CT-DECT transceivers that are not intrinsically safe (explosion-protected) and therefore do
not have any special hazardous duty marking must never be used in potentially explosive
atmospheres. Unprotected CT-DECT transceivers can trigger explosions unintentionally in
these areas.
CeoTronics does not assume any liability for damage to property and personal injuries of any
kind that can arise through the above mentioned or any other incorrect use of the CT-DECT
transceivers.
1. Important safety instructions
For the use of the device notice the national safety and accident prevention regula-
tions and the following safety instructions shown in italics in this instruction manual.
z Before using CeoTronics products read completely the appropriate operating instructions. If in
doubt, ask our technical staff.
z If repair work of any kind needs to be done to CeoTronics products, arrange for it to be performed
only by the company CeoTronics or by a specialized workshop that is authorized by CeoTronics.
In all other cases our warranty and liability for the product shall lapse.
z If products are operated on a mains voltage, always pull the mains plug out of the mains plug so-
cket before opening such products (e.g. for servicing purposes)!
z Do not store CeoTronics products outside or in damp ambient conditions. At all times keep them
clean, dry and at normal air humidity. CeoTronics products must not be stored in areas with a
temperature of over +80° C (+176° F), e.g. in the summertime on the parcel shelf of a car. If not
stated otherwise, the following temperature ranges are allowed for CeoTronics products: -10 to
+55° C (+14 to +131° F) for operation, -40 to +80° C (-40 to +176° F) for storage.
z Do not immerse a CeoTronics product into water, if it is not expressly specified for this purpose.
z When using CeoTronics products that are equipped with connection leads ensure that the latter
do not get caught up in operational machinery or wheels!
z CeoTronics products that are not intrinsically safe (explosion-proof) and therefore have no special
explosion-proof designation must never be operated in potentially explosive environments (e.g.
when refuelling cars, aircraft etc.). Devices that are not explosion-proof can unintentionally trigger
off explosions in such areas!
z Connect CeoTronics accessories to a device or disconnect them from a device only when the
device is switched off.
z If you are a cardiac pacemaker carrier, before operating a transmitter/receiver ask the manufac-
turer of your cardiac pacemaker for information about any impairment that might be caused
due to high frequencies.
z When on board an airplane always keep a transmitter/receiver switched off. Operation of the
transmitter/receiver could affect the safety of the airplane and it is therefore prohibited. Never op-
erate electronic devices on board an airplane without the express approval of an authorized
member of the cabin crew.
z Do not leave CeoTronics products lying around loose in cars, e.g. on the parcel shelf. Stow these
products in a suitable, safe place in the car so that they do not present a danger to you or to other
occupants of the car, if emergency braking is effected.