User's Manual
Table Of Contents
- 1.Important safety instructions
- 2.Description
- 3.On-air subscription
- 4.Commissioning and operation
- 5.Safekeeping – storage
- 6.Recharging the batteries
- 7.Maintenance
- 8.Accessories and consumable parts
14
4. Commissioning and operation
Î NOTE
In the following the commissioning and operation of the system is described for the Aircraft
Interface and the Transmitter/Receiver Units CT-GateCom II.24/Multi which are used in
conjunction with communication headsets.
4.1 Aircaft Interface
The rechargeable battery in the Battery Pack must be fully charged.
a. Open the carrying bag for the Aircraft Interface by means of the zip.
b. Take the connecting cable (Fig. 11/a) with male jack-plug (Fig. 11/c) out of the cover of the carrying
bag. Lead the connecting cable with male jack-plug through one of the loops (Fig. 11/b) on the
carrying bag. Close the carrying bag by means of the zip. This prevents any fluids running along
the lead into the carrying bag.
Fig. 11
c. At the aircraft locate the aircraft intercom connector. Hang the carrying bag e.g. over the access
cover or to a suitable place near the aircraft intercom connector by means of the carrying strap or by
means of a hook.
Connect the Aircraft Interface via the connection cable and the male jack-plug to the female jack-
plug for the aircraft intercom.
Î NOTE
z
Keep the carrying bag for the Aircraft Interface closed at all times while in use!
4.2 Headsets and Transmitter/Receiver Units
a. Connect the headset via the connecting cable and plug to its Transmitter/Receiver Unit. Fasten the
Transmitter/Receiver Unit by means of the clip on the rear to a suitable place on your clothing.
b. Put on the headset. Take care for a perfect comfortable fit. Only when the ear cushions are properly
located around the ears the best noise attenuation of the ear muffs is provided. Adjust the height of
each ear muff equally on both sides while holding the head band down until the ear cushions have a
tight and comfortable fit. The head band should sit straight and comfortable on the top of the head.
For hygiene reasons we recommend the use of the washable sweat absorbers on the ear muffs.
These are pulled over the ear cushions and are for the purpose of wear comfort and hygiene.