User's Manual

2.8 Battery charger

The rechargeable Li-Ion battery 3.6 V/2300 mAh in the Battery Pack of the Aircraft Interface should only

be charged with the charger supplied with the system (see section 2.3). For recharging the battey see

section 5 and the special CeoTronics users manual for the charger.

3. Commissioning and operation

Î NOTE

In the following the commissioning and operation of the system is described for the Aircraft

Interface and the Transmitter/Receiver Units CT-GateCom II.24/Multi which are used in

conjunction with communication headsets. The Aircraft Interface contains the Transceiver

Module CT-DECT-I24.

3.1 Aircaft Interface

The rechargeable battery in the Battery Pack must be fully charged.

a. Open the carrying bag for the Aircraft Interface by means of the zip.

b. Take the connecting cable (Fig. 3/a) with male jack-plug (Fig. 3/c) out of the cover of the carrying

bag. Lead the connecting cable with male jack-plug through one of the loops (Fig. 3/b) on the

carrying bag. Close the carrying bag by means of the zip. This prevents any fluids running along

the lead into the carrying bag.

Fig. 3

c. At the aircraft locate the aircraft intercom connector. Hang the carrying bag e.g. over the access

cover or to a suitable place near the aircraft intercom connector by means of the carrying strap or by

means of a hook.

Connect the Aircraft Interface via the connection cable and the male jack-plug to the female jack-

plug for the aircraft intercom.

Î NOTE

Keep the carrying bag for the Aircraft Interface closed at all times while in use!