Instruction Manual Para instrucciones en Español, llamar al: 1-800-837-4044 www.centuryproducts.
TABLE OF CONTENTS Operations and Adjustments......................... 12 • Harness Straps • Harness Tie • Buckle • Recline / Upright Positions • Changing Harness Strap Slots Instruction manual is for: SmartMove 5-Point Newborn/Toddler Car Seat ® ❃ Before You Begin ❃ Special Information Important Information.....................................1 Warnings.........................................................2 Basic Information.............................................4 ❃ Use Height & Weight Limits.
IMPORTANT INFORMATION No car seat can guarantee protection from injury in every situation, but proper use helps reduce the risk of serious injury or death. ❃ Safety First Check List ✔ Read and understand instruction manual and car seat labels. ❃ Registration Information Child restraints (car seats) could be recalled for safety reasons. You must register this restraint to be reached in a recall.
WARNINGS - Prevent serious injury or death: Failure to follow these instructions and car seat labels can result in child striking the vehicle’s interior during a sudden stop or accident. Secure child restraint with a vehicle seat belt as shown in this manual. Infants less than 20 lbs. (9.1 kg) must use this car seat rear-facing. Serious crippling injury or death can result if infant faces front of vehicle. Vehicle seat belt system MUST hold car seat securely.
WARNINGS - Prevent serious injury or death (continued): DO NOT use car seat if it is damaged or has missing parts. DO NOT use accessories or parts other than those provided by Century or Graco. Their use could alter the performance of the car seat. Rear-facing car seat must be properly leveled: • Too reclined can result in injury or ejection. • Too upright can result in breathing difficulties. Never leave child unattended, even when sleeping. Child may become tangled in harness straps and suffocate.
BASIC INFORMATION ❃ Certification ❃ Unoccupied Car Seat This car seat meets or exceeds all applicable requirements of Federal Motor Vehicle Safety Standard 213 for use in motor vehicles and aircraft. ❃ Warm Weather ❃ Car Seat Useful Life DO NOT use after date shown on back of car seat due to changing requirements and normal wear and tear. Look for: Do not use this car seat after December ❃ Dangerous Vehicle Seats Do not use car seat on rear-facing or side-facing vehicle seats.
HEIGHT & WEIGHT LIMITS Rear-facing: Birth to 30 lbs. (13.6 kg) • Infants from birth to 20 lbs. (9.1 kg) MUST be rear-facing. ❃ Preterm or Low Birth Weight Infants • Infants or toddlers 20 to 30 lbs. (9.1 to 13.6 kg) may be rear-facing. A preterm infant or low birth weight infant may be at special risk in a vehicle or aircraft. IMPORTANT: This car seat is certified for use rear-facing with children up to 30 lbs. (13.6 kg). However, some children approaching 30 lbs. (13.
REAR-FACING INSTALLATION 4 WARNING To prevent serious injury or death: Do not allow anything in vehicle interior or in base of car seat to obstruct rotation in a crash. When using car seat rear-facing, car seat MUST be able to rotate freely from a reclined to an upright position on impact. • Test by moving car seat through all seating angles. 1 2 3 6 Adjust car seat to reclined or semi-reclined position and place rear-facing on vehicle seat.
REAR-FACING INSTALLATION (continued) Openings Towels (fig. e) (fig. a) (fig. b) (fig. c) (fig.
FORWARD-FACING INSTALLATION 1 2 3 4 Adjust car seat to upright or semi-upright position and place forward-facing on vehicle seat. Thread vehicle seat belt through openings and behind harness straps (fig. a). Buckle belt. Press down firmly in center of car seat to compress vehicle seat cushion while tightening vehicle seat belt. HINT: Use your knee to press down in center of car seat (fig. b). Pull front to back and left to right to check for secure installation (fig. c). Vehicle lap belt MUST stay tight.
FORWARD-FACING INSTALLATION (continued) Openings Pull to tighten (A) (B) (fig. a) (fig. b) (fig. c) (fig.
PLACING CHILD IN CAR SEAT 1 Place child in car seat with child’s back flat against back of car seat. 2 Place harness straps over child’s shoulders and insert tongues into buckle. WARNING To prevent serious injury or death: • Keep harness straps snug and positioned on shoulders. • Do not use strap covers, blankets, cushions, or padding under harness straps or child unless provided by Century or Graco. • Child must be dressed in clothing with arms and legs that will not interfere with buckling harness.
PLACING CHILD IN CAR SEAT (continued) 3 2 4 (fig. a) (fig.
OPERATIONS and ADJUSTMENTS 1 Harness Straps (fig. a): • To tighten: Pull lower belt tab. • To loosen: Pull and hold upper belt tab while pulling harness straps out. 2 Harness Tie: • To open: Press tab and pull apart. • To close: Snap halves together. Make sure harness tie is locked by pulling out on each half. 3 Buckle: • To buckle: Insert both tongues into buckle. Pull up on tongues to be sure they are locked. • To unbuckle: Press red button and pull tongues out of buckle.
OPERATIONS and ADJUSTMENTS (continued) 1 2 3 4 Upper Lower (fig. a) (fig. b) (fig.
OPERATIONS and ADJUSTMENTS 7 Changing Harness Strap Slots: A Loosen harness straps: Pull and hold upper belt tab. (continued) D Re-attach harness strap loops to Splitter Plate (fig. e): • For Infants or Small Toddlers: Pull harness straps out. Put Top right strap loop on Splitter Plate first, then attach Top left strap loop. B Remove both harness strap loops from Splitter Plate on back of car seat. NOTE: Make sure ends of straps are in front of Splitter Plate as shown. C Change harness strap slots.
OPERATIONS and ADJUSTMENTS Top Loop (continued) Splitter Plate Bottom Loop Rear Recline Lever (fig. e) (fig.
VEHICLE SEAT BELTS WARNING Not all vehicle seat belts can be used with a car seat. The car seat must be held securely at all times by a lap belt (or lap belt portion of a lap/shoulder belt) that will not change length while driving. To provide the most secure installation of the car seat: • Read the vehicle owner’s manual regarding car seat installation and seat belt use with car seat. • Follow all instruction labels on vehicle seat belt and car seat.
VEHICLE SEAT BELTS (continued) ❃ Belts Forward of Seat Crease Vehicle seat belts located forward of seat crease may not securely hold car seat. Check vehicle owner’s manual or see vehicle dealer for car seat installation requirements. Seat Crease • If approved for use with car seat, install car seat and check for secure installation by pulling car seat front to back. If car seat slides forward, DO NOT use these seat belts.
VEHICLE SEAT BELTS (continued) ❃ Lap Belts - Manually Adjustable The locking latch plate on some seat belts may slip and loosen after being buckled on car seat if positioned at a certain angle. If this happens, flip latch plate over (fig. a) and re-buckle. Test installation again to see if this works. If not, move car seat to another seating position. Flip ❃ Lap Belts - With Retractor Lap belts with retractors may or may not hold a car seat securely. (fig.
VEHICLE SEAT BELTS (continued) ❃ Passive Restraint - Lap Belt with Motorized Shoulder Belt DO NOT use with any car seat. ❃ Passive Restraint - Lap or Shoulder Belt Mounted on Door DO NOT use with any car seat. Belts will not stay tight while driving.
VEHICLE SEAT BELTS (continued) ❃ Combination Lap/Shoulder Belt with Sliding Latch Plate Pull on latch plate (fig. a). If belt slides freely through latch plate, a locking clip MUST be used (see Locking Clip section). Pull Some combination lap/shoulder belts with sliding latch plates may be converted into an “automatic locking mode” that will allow use without a locking clip. See vehicle owner’s manual and label on vehicle belts for instructions. (fig.
VEHICLE SEAT BELTS (continued) ❃ Locking Clip WARNING • Failure to use locking clip where required will result in car seat not being securely held in place. • Shorten length of lap belt portion slightly by pulling belt through latch plate. You MUST use locking clip provided with car seat with a vehicle seat belt that slides freely through the latch plate or the lap belt cannot be tightly secured. 3 4 If not secure, additional belt tightening may be required: • Unbuckle vehicle seat belt.
ADDITIONAL INFORMATION ❃ Installation of Anchor Hardware Vehicle may already be equipped with a tether anchor (top strap anchor). See vehicle owner’s manual for location. If vehicle does not have a tether anchor, one must be installed: • Contact vehicle dealership for proper anchor location and installation. • Before installing anchor, install car seat on a vehicle seat and check that the lap belt portion of the vehicle belt will hold car seat securely. If not, move car seat to another seating position.
ADDITIONAL INFORMATION ❃ Tether Storage (continued) Tether Hook DO NOT anchor tether strap to the vehicle when using car seat rear-facing. Tether hook must be attached to car seat for rear-facing use. For storage of tether hook: • Attach tether hook to back of car seat using one of the locations shown. Tether Hook • Pull loose end of strap to remove any slack. • Roll loose end of strap up and secure with a rubber band.
ADDITIONAL INFORMATION (continued) ❃ Care & Cleaning 2 Removing Seat Pad: 1 2 3 Remove both harness strap loops from Splitter Plate on back of car seat. Pull harness straps out of harness slots. Remove tongues and from harness straps. 5 Unhook “J” hooks from car seat shell. 4 5 Pull seat pad up over harness straps leaving harness straps in car seat. Reverse above steps for replacing seat pad, and harness system. 24 5 Remove from harness tie from harness straps.
ADDITIONAL INFORMATION Seat Pad: Machine-wash separately on gentle cycle and drip dry. Harness Straps: Surface wash only with mild soap and damp cloth. If harness straps are frayed or heavily soiled, they MUST be replaced. Shell: (continued) ❃ Aircraft Use This car seat is certified for use on aircraft (see label on car seat). Contact airline about their policy. Use this car seat only on forward-facing aircraft seats. Install car seat on an aircraft the same way it is installed in a vehicle.
1 2 Fold instruction manual. Store instruction manual behind these tabs. If a part is damaged, missing, or you need help or replacement parts, DO NOT return car seat to the store. CALL US FIRST Call toll-free 1-800-837-4044 from anywhere in the U.S. or Canada or fax at 1-610-286-4555. or write us at: Century Products P.O.Box 100 Elverson, PA 19520-9974 Attention: Customer Service Department Store Locking Clip on bottom of car seat.
