Do not use this 4-in-1 System until you read and understand these instructions! English PM-0624AB 3/98 ENGLISH CAR SEAT/ STROLLER INSTRUCTION MANUAL
IMPORTANT INFORMATION ENGLISH Thank you for selecting this 4-in-1 System Pro Sport Plus Car Seat/Stroller which has many uses: • Infant car seat • Carrier • Car seat/Stroller • Stroller ❃ Need Help? If you need help with this product, call toll-free 1-800-837-4044 from anywhere in the U.S. or Canada. Outside these areas please call 330-963-2800 8:00 AM until 6:00 PM E.S.T. Monday through Friday.
WARNINGS Avoid serious injury from falling or sliding out. Always use seat belt. Avoid serious injury or strangulation, DO NOT place child in stroller seat when car seat adapter is attached. Remove adapter assembly BEFORE using stroller seat. DO NOT pull or carry stroller on stairs or escalators with child in it because child could fall out and be injured. DO NOT lift car seat/stroller unit by car seat handle. Handle may break.
CAR SEAT/STROLLER ASSEMBLY ENGLISH ❃ Lock Footrest: 1 Push footrest down so that frame tube is centered between three (3) tabs on bottom of footrest and snaps into place. Tabs Stroller Right Side Stroller Left Side ❃ Rear Wheel Assembly: 1 Remove axle protectors from ends of axle and discard. 2 Rotate brake lever to the unlocked Brake Lever position and slide wheel onto each end of axle rod with brake ribs facing in.
CAR SEAT/STROLLER USAGE ❃ To Attach Car Seat continued 1 Step down on brake lever to lock 3 Push in red button on each handle brakes. hub and rotate handle back until it “clicks” and locks just behind car seat. ENGLISH ❃ To Attach Car Seat Adapter: Red Button 2 Release both levers on sides of seat back. 4 Pull up on both handle hubs to be sure car seat is locked in car seat adapters. NOTE: Stroller seat back MUST be in reclined position to use car seat adapter.
STROLLER USAGE ENGLISH ❃ To Remove Car Seat Adapter: ❃ To Attach Napper Bar: (Stroller can be used with or without Napper Bar.) WARNING 1 Align napper bar (flat side down) STRANGULATION HAZARD! Remove car seat adapter BEFORE using as a stroller seat. 1 Squeeze tab in adapter bracket with slots in lower part of handle bracket. 2 Push napper bar into slots. Pull to unlock bracket. napper bar to be sure it is locked.
SPECIAL INFORMATION ❃ Folding and Storing continued: 1 Step down on brake lever to lock IMPORTANT: brakes. 2 Remove car seat from stroller frame (see page 4). • When folding stroller, turn stroller front wheels to straddle frame. ENGLISH ❃ Folding and Storing: • DO NOT allow front wheels to rest on frame. Doing so will cause wheels to warp and they will not roll correctly. NOTE: Car seat adapter may remain on stroller when folding.
REPLACEMENT PARTS ENGLISH PARTS LIST PRICE A. Front Wheel Assembly 2-Preassembled Wheels (11-65X) $ 7.50 B. Rear Wheel Kit 1-Wheel, Wheel Retainer Clip & Retainer Cap (11-65X) 4.95 C. Hub Cap Set (2) (11-65X) 2.75 D. Seat Pad (11-65X) 13.00 E. Comfort Pad (11-65X) 9.50 F. Canopy Pad (11-65X) 6.50 G. Canopy Frame (11-65X) 2.65 PART A B C D E F G H. Car Seat Adapter with Brackets (11-65X) 6.95 H I. Mesh Basket (11-65X) 7.50 I J. Napper Bar (11-652 ONLY) 4.50 J K.
ENGLISH REPLACEMENT PARTS ORDER FORM Please fill out and return this form to address shown on back of page. A. Front Wheel Assembly $ B. Rear Wheel Kit $ C. Hub Cap Set $ D. Seat Pad $ E. Comfort Pad $ F. Canopy Pad $ G. Canopy Frame $ H. Car Seat Adapter with Brackets $ I. Mesh Basket $ J. Napper Bar $ K.
ENGLISH Send order with check, money order, or charge card number, in an envelope to: Century Products Company 9600 Valley View Road Macedonia, OH 44056-2096 Attention: Consumer Relations Department You put more than your trust in us.
