Specifications

K. CHANNEL SELECT - When this button is
pressed, the amp switches from the NORMAL
channel to the DRIVE channel.
L. MASTER - Adjusts the overall volume of the
DRIVE channel .
M. REVERB - Adjusts the amount of reverb present
in both the NORMAL and DRIVE Channels.
N. PRESENCE - Adjusts the amount of very high
frequencies present in both the NORMAL and
DRIVE Channels.
O. PREAMP OUT - This unbalanced jack provides
an output signal from the preamp and is pre-reverb.
It may be used to drive effects units in an effects
loop, to drive additional amplifiers in a multi-amp set
up, or as a preamp send to a mixing console.
P. POWER AMP IN - This unbalanced jack provides
a return from your effects units and is pre-reverb. This
jack can also be used as a power amp input.
Q. FOOTSWITCH (INCLUDED) - Plug-in connection
for the remote footswitch to select between the
NORMAL and DRIVE channels and to select "More
Drive". Using the footswitch overrides the front
panel select buttons. NOTE: Any good quality patch
cord will work with the remote footswitch, however, a
speaker grade cord is preferable to a coax guitar cord.
R. PILOT JEWEL - Illuminates if the Hot Rod
Deluxe is receiving power. Should this bulb burn
out, turn off and unplug the amplifier, unscrew the
red jewel and replace the lamp with a type T47 bulb.
S. STANDBY SWITCH - Turns the amplifier on and
off. In the STANDBY position, the amplifier is off.
When the "On/Off" switch (item T) is turned on,
power is supplied to the tube filaments eliminating
warm-up time. Using the STANDBY SWITCH during
short breaks versus using the on/off switch will
increase tube life.
T. POWER SWITCH - Turns the AC power ON
and OFF. When the amplifier is in the OFF position,
the amplifier is completely shut down.
7
ON
OFF
ON
STANDBY
CHANNEL
SELECT
12
11
10
9
8
7
1
12
2
11
3
10
49
58
6
7
1
12
2
11
3
10
49
58
6
7
1
12
2
11
3
10
49
58
6
7
PRESENCE
REVERB
MASTER
D
LE
POWER
AMP IN
PREAMP
OUT
FOOT
SWITCH
K
L
MN
O
P
Q
R
S
T