Instruction manual

Washout Base
(CNE516)
Linkage Ball
(CNLR1014)
Washout Control Arm
(CNE516)
Bearing 3x6x2.25
(CNBB36)
Cap Screw M3x8
(CNM3x8CS)
Flat Washer M3x5x.5
(CNLR1003)
Medium Linkage Ball
(CNLR1020)
Antirotation Linkage Ball
(CNE515)
*Hint: Undue the cap screws and linkage balls to the assembled parts. Apply CA
on metal to plastic assembly. Apply blue thread lock on metal to metal assem-
bly. Do not over tighten when screwing the attaching assembly to its subassembly.
Swashplate
(CNE515)
Swashplate and Washout Assembly
6. Assembly Instructions
CA
Main Shaft
(CNE508)
Flybar outer
fl at spot
Equal fl ybar length
on each side
Flybar control arms must
be level with Seesaw. Set
screws face upward.
Flybar outer fl at spots align
with fl ybar control arms when
arms are fl ush with seesaw.
THREAD LOCK
Adjusting the Flybar
Apply Thread lock to the inner
steel ball links
THREAD LOCK
R
7.