Instruction manual

Flybar Paddle Cover
Flybar Paddle
Flybar
Wipe the paddles with 70% Isopropyl alcohol making
sure that it is free from oil. Use the fl ybar paddle cover
found on the decal sheet. Wrap around the fl ybar paddle.
Hint: Cover the bottom end of the fl ybar paddle and adhere the ex-
cess covering material to the trailing edge of the fl ybar paddle. Tightly
pull the top side of the cover over the fl ybar paddle, fl ush with the
trailing edge and cut the excess material along the trailing edge.
Trailing Edge
Preparing the Flybar Paddles
6.
OIL
Add a small
amount of
Synthetic Hydro
Carbon Grease
Thrust Bearing
(CNBB614T2)
Linkage Ball
(CNLR104)
Cap Screw M3x16
(CNM4x16)
Bearing M3x6x2.5
(CNBB364)
Brass Spacer M3x5x3
(CNE524)
Bell Mixing Arm
(CNE524)
Bearing M3x6x2.5
(CNBB364)
Cap Screw M4x10
(CNM4x10CS)
Washer M4x9
(CNM4x8x1FW)
Flat Washer M10x14x1
(CNE521)
Bearing 8x14x4
(CNBB814)
M3 Locknut
Main Blade Grip
(CNE523)
Bearing 8x14x4
(CNBB814)
Brass Washer M8x12x3
(CNE522)
Rubber Dampener
(CNE520)
Spacer M3x5x2
(CNE524)
Cap Screw M4x30
(CNM4x30)
*The thrust bearing washer with the bigger inner race should
be closer to the head block. The thrust bearing washer with
the smaller inner race should be closer to the rotor blade.
*Raised lip should
be facing the bearing
6. Assembly Instructions
Main Blade Grip
CA
THREAD LOCK
B
Attaches to feathering
shaft on the following page