Instruction manual

3. Required Items for Operation
Part#CN2015 Hardened Tip Hex Screw Driver Set
Part#CN2026 Pitch Gauge with Paddle Gauge
Part#CN2034A 15
0
Curve Tip Ball link Pliers
Part#CN2052 Main Blade Balancer
Part#CN2055 Ball Link Sizing Tool
Part#CN2070 Universal Flybar Lock
Part#CN2219 Ball Link Easy Driver
Part#CN2255 Control Rod Gauge
Part#CNWI26555 5.5mm Nut Driver
Part#CNWI26570 7.0mm Nut Driver
Hobby scissors
#CN2262
Hardware Description and Identifi cation: M3x6 = 3x6mm and can refer to screws or ball bearings.
M3x6 Phillips Machine Screw
M - metric
3 - diameter
6 - length
M3x6 Self Tapping Screw
M - metric
3 - diameter
6 - length
M3x10 Socket Cap Screw
M - metric
3 - diameter
6 - length
M3x7x3 Ball Bearing
M - Metric Value
3 - Inside
7 - Outside
3 - Thickness
Necessary Items “Not Included” in the kit.
IMPORTANT: 6 Channel helicopter radio or
better with 120
o
eCCPM mixing required.
PG2000 II Dual Rate Piezo Gyro
#CN2018 (or equivalent)
Brushless Electric Motor
#CNE455
Electron 55 Brushless Speed
Control w/ Heat Sink
This is the general list of items required to get the Swift helicopter fl ying. Century produces a full spectrum of accessories and tools to
assemble your helicopter. The Swift is a mechanical cyclic collective pitch mixing type helicopter requiring a standard helicopter radio
(the helicopter radio does not require eCCPM type mixing for this model). The Swift uses 4 servos to operate critical systems. Gyro-
scopes are required to operate the model safely.
Recommended Tools & Accessories
Screwdrivers - Slotted and Phillips head
Long-Nosed Pliers
Allen Wrenches - 1.5mm, 2.0mm, 2.5mm + 3.0mm
Appropriate Socket Wrench
Hobby Scissors
Double Sided Foam Tape ( 1/16” - 3/32” )
Foam Rubber ( Radio Packing )
Thread lock liquid (e.g. Locktite)
Hobby Grease (Super Lube)
Oil to lubricate sliding shafts
CA (Cyanoacrylate) Glue
The tools and materials listed below are
the minimum needed to build the helicopter:
In addition, the following will make assembly and setup
easier, and prove useful later in your model toolbox:
Main Blade Pitch Gauge
w/Paddle Gauge
#CN2026
Locktite
#CN2025BS blue
#CN2025RS red
Lubrication
#CN2024T
Needle Nose Pli-
ers & Cutter Pliers
Fastener and ball bearing dimensions
Servos (4)
Receiver
Transmitter
Receiver
Battery
Pack
Power plant
battery pack
4S-6S Li-Po or
12 Cell NiMH
WARNING: Do not overtighten bolts or screws possibly damaging threads of bolts or components.
4.