Owner's Manual

PAP M92 & M85 Pistol Manual

Page 11

6. Remove the bolt carrier and bolt from the pistol by holding the receiver with one hand and

the cocking handle with your other hand. Pull the bolt carrier and bolt to the rear as far as

possible. Once the back of the bolt carrier contacts the back plate of the receiver, release

pressure on the bolt cocking handle, this will allow the bolt carrier to move up and off the

receiver rails. Lift the rear portion of the bolt carrier and remove it and the bolt from the

receiver. (See Illustration #13.)

7. Remove the bolt from the bolt carrier by turning the bolt carrier over and holding it in one

hand. (See Illustration #14.) Rotate what is now the top of the bolt to the right and move it

rearward with your other hand so that the guide lug on the bolt leaves the channel in the bolt

carrier. You can now remove the bolt from the bolt carrier by moving it forward and out of its

guide hole.

Illustration #13

Illustration #14

Reassembly

1. Attach the gas tube assembly and upper handguard by holding the pistol by the forward

portion of the receiver with one hand, and with your other hand install the front end of the gas

tube on the gas block. Align the gas tube end with its groove in the rear sight base and rotate it

downward until it is fully seated in the rear sight base. When the gas tube assembly is fully

seated in the rear sight base, the gas tube securing pin will move out and over the gas tube to

lock it in place.

2. Install the bolt back in the bolt carrier by first holding the

bolt carrier upside down in one hand with the gas

piston facing away from you. Then take the bolt in

your other hand with the bolt face facing away from

you and the guide lug facing upward. Insert the bolt

shaft into the guide hole on the bolt carrier and

bring the bolt fully rearward. Align the bolt guide lug

with the channel in the bolt carrier and rotate the

bolt to the left. Once the guide lug has entered the

channel in the bolt carrier continue to rotate until

the bolt has moved forward as far as possible. (See

Illustration #16.)

Illustration #16

8. Remove the gas tube assembly and upper

handguard from the pistol by holding the

forward portion of the receiver with one hand

and pressing in the gas tube securing pin. (See

Illustration #15.) Then, lift the gas tube end

vertically out of its groove in the rear sight base

and remove the front end of the gas tube from

the gas block.

Illustration #15