Safety Manual

down, move the rear sight down. To move your group to the left, move

the sight left. The receiver is drilled and tapped to accept Mauser 98

scope bases available through your local gun dealer.

SAFETY:

To place your rifle in a safe position, draw back and up on the cocking

handle until the handle is completely in the top of the safety notch. No

safety is foolproof. Always keep the muzzle pointed in a safe position.

DISASSEMBLE:

Insure that your rifle is unloaded and there is no cap on the nipple before

you proceed.

1. Remove the ramrod.

2. Remove the stock by unscrewing the forward trigger guard

screw and the front sling swivel.

3. With the bolt in the forward position, unscrew the bolt spring

cap. Note this cap is under spring tension, USE CAUTION!

4. Remove spring and follower.

5. With the trigger pulled back, move the bolt fully rearward

and remove the cocking handle. Slide the bolt from the

receiver.

6. Remove the trigger assembly by unscrewing the two Allen

head screws.

7. Using the tool provided (in the butt of the rifle) remove the

nipple and breech plug.

Reassemble by reverse order.

CLEANING YOUR RIFLE:

Black Powder residue is highly corrosive. The rifle should be cleaned and

lubricated after each use.

Strip the rifle as in the disassembly section.

muzzle6.qxd 10/11/2001 10:18 AM Page 11