Instruction Manual

Illustration #5
Illustration #6
Illustration #7
Illustration #8
Page 2 AK Double Trigger Kit Manual
Illustration #1
Illustration #2
Illustration #4
Illustration #3
7. While holding the hammer down pull the trigger to release the hammer and slowly let it go
forward. Place needle nose vise grips locked on the hammer. (See Illustration #1.) Move the
hammer spring arms onto the vise grips. (See Illustrations #2 - #3.)
8. Remove the shepherds hook from the trigger pin (See Illustration #4), then remove the trigger
pin. (See Illustration #5.)
9. Remove the safety lever and the shepherd hook from the receiver. Lift the trigger mechanism from
the gun.
10. Leaving the vise grips on the hammer, push the hammer pin over and remove it from the
receiver. Slide the vise grips with the hammer to the back of the receiver and lift out. (See
Illustration #6.))
11. Use the pliers to grasp the spring legs one at a time, slightly lift them and pull out to the side to
release the tension. (See Illustration #7.) CAUTION:The spring is under tension!
12. Once the tension is removed from the spring, remove the spring from the hammer. Make sure to
note the position of the spring. (See Illustration #8.)
13. Remove the pistol grip.