Instruction Manual

©
2014 Century International Arms, Inc. All rights reserved.
WARNING: Make sure your firearm is not loaded! Remove the magazine and
inspect the chamber to ensure it is empty!
To install your new AK Double Trigger, you first need to disassemble your firearm.
WARNING: Before beginning the disassembly process, check to ensure the
firearm is not loaded.
1. Remove the magazine from the firearm.
2. Move the safety lever to the "FIRE" position by rotating the safety lever downward.
3. Check the chamber to ensure it does not contain a round by pulling back on the bolt cocking
handle. Inspect the chamber to ensure it is empty. Once you determine the chamber is empty
and no magazine is in the firearm, let the bolt go forward.
4. While maintaining a safe muzzle direction, remove the receiver cover by holding the firearm in a
secure position (across your lap, resting on a table, etc.) and grasping the rear part of the
receiver with your right hand, press the recoil spring cam forward. Then remove the receiver
cover from the back end first with your left hand.
5. Remove the recoil spring assembly from the firearm by holding the forward portion of the
receiver with your left hand and pressing on the back of the recoil spring cam with your right
hand until its rear face leaves the groove in the rear of the receiver. Lift the recoil spring cam
and remove the recoil spring assembly from the bolt carrier channel. NOTE: The recoil spring
assembly is under spring pressure. Hold firmly on to the assembly when removing it or
injury could result.
6. Remove the bolt carrier and bolt from the firearm by holding the receiver with your left hand
and the cocking handle with your right hand. Pull the bolt carrier and bolt to the rear as far as
possible. Once the back of the bolt carrier contacts the backplate of the receiver. Lift the rear
portion of the bolt carrier and remove it and the bolt from the receiver.
Package Includes
1. Trigger Assembly (trigger, disconnector,
disconnector spring, bushing)
2. Triggerguard
3. Magazine release lever
4. Magazine release lever pin
5. C-Clip
6. Hammer
AK DOUBLE TRIGGER KIT
INSTRUCTION MANUAL
100% AMERICAN MADE!
Installation Tools Required
1. Hammer
2. Flat Screwdriver
3. Needle Nose Vise Grips
4. Pliers
5. Hack Saw or Motorized Cut Off Tool
6. File/Sandpaper
7. Punch
Disassembly
Visit the manuals tab on our website at
www.centuryarms.com for downloadable
PDF and to watch instruction video.

Summary of content (4 pages)