Installation manual

!
Make sure that an earth leakage circuit breaker with a
threshold of 30mA is fitted upstream of the system
!
Never short circuit the battery and do not try to recharge the
batteries with power supply units other than that supplied with
the product, or by CENTSYS
!
Make sure that the earthing system is correctly constructed,
and that all metal parts of the system are suitably earthed
!
Safety devices must be fitted to the installation to guard
against mechanical movement risks such as crushing,
dragging and shearing
!
It is recommended that at least one warning indicator light be
fitted to every system
!
Always fit the warning signs visibly to the inside and outside of
the gate
!
The installer must explain and demonstrate the manual
operation of the gate in case of an emergency, and must hand
the User/Warnings guide over to the user
!
Explain these safety instructions to all persons authorised to
use this gate, and be sure that they understand the hazards
associated with automated gates
!
Do not leave packing materials (plastic, polystyrene, etc.)
within reach of children as such materials are potential
sources of danger
!
Dispose of all waste products like packaging materials, worn
out batteries, etc, according to local regulations
!
Always check the obstruction detection system, and safety
devices for correct operation
!
CENTSYS does not accept any liability caused by improper use
of the product, or for use other than that for which the
automated system was intended
!
This product was designed and built strictly for the use
indicated in this documentation. Any other use, not expressly
indicated here, could compromise the service life/operation of
the product and/or be a source of danger
!
Everything not expressly specified in these instructions is not
permitted
Page 4