Installation manual

Page 48
Line of gates when closed
M gate closes
slightly behind
S Gate (Leaf delay)
S Gate closes first
Mechanical lip
*
M Gate continues to close
“Short Stop”
*
S Gate stops slightly before closed position
If “Short Stop” is correctly set, PCM will cut off
when gates reach closed position, in line
!
The amount of force applied by the
actuator when in PCM can be set as
a value from 1 to 15
!
Leaf delay value
The leaf delay is based on piston
position, and can be adjusted from
3mm to 250mm of piston travel.
!
Pre-open delay
Allows a delay between a valid
trigger signal being received and
the gate commencing movement in
the opening direction. A warning
light can be set to activate during
this delay. (Refer to Pre-flash
modes of the feature, for more
details). This setting applies to both
motors
Short Stop value
The Short Stop distance can be set
between 1mm and 40mm of piston
stroke.
PCM push force
Leaf delay
Leaf delay is used in cases where
one gate leaf must move before the
other. The most common need for
this arises when a mechanical 'lip' is
fitted to one of the gates. In a
double leaf installation, a leaf delay
can be set whereby the M motor will
open before the S motor, and the S
motor will close before the M motor
!
!
!
Pre-close delay
Allows a delay between a valid trigger signal being received and the gate
commencing movement in the closing direction. The delay will also occur if the
gate is set to close automatically. A warning light can be set to activate during
this delay. (Refer to Pre-flash modes of the feature ‘Pillar Light’, for more
details). This setting applies to both motors
!
Opening speed
Sets the maximum piston opening speed in millimeters per second.
This setting applies to both motors
!
Closing speed
Sets the maximum piston closing speed in millimeters per second. This setting
applies to both motors
Mechanical lip on
M Gate engages with S Gate
With PCM, Master Gate continues closing,
pushing the Slave Gate with it
*
*
FIGURE 63.
FIGURE 64.
FIGURE 65.
FIGURE 66.