Installation manual

Page 34
4. Check that the charger and battery are
connected to the controller.
Ensure the battery polarity is correct.
5. Switch on the mains supply (via isolator).
6. Ensure that both the controller and charger
are effectively earthed for improved
lightning protection.
7. Check that the origin has been correctly set.
(See page 24).
8. Check that the gate is closed and the
operator is locked.
S Sens1
S Sens2
M Sens1
M Sens2
Sens+
Sens-
Safe CLS
Safe OPN
Com
LCK/STP
TRG
33333
Exit Go
Up/Dn
Exit Go
Up/Dn
Exit Go
Up/Dn
Exit Go
Up/Dn
Exit Go
Up/Dn
Exit Go
Up/Dn
Exit Go
Up/Dn
Exit Go
Up/Dn
Exit Go
Up/Dn
AutoCloseAutoCloseAutoCloseAutoCloseAutoClose
9. If powering up the system ex-factory, it will
request for the operating PROFILE
(operating standard) to be set. Select from
the list the PROFILE that will suit the
specific region. With this set, the system
will automatically proceed to the limit
setup menu. Follow the on-screen instruc-
tions to complete the set-up procedure.
If the powering up with the PROFILE set
but no limits set, the system will automati-
cally proceed to the limit setup menu.
Follow the on-screen instructions to
complete the set-up procedure.
If powering up at any stage after that, push
and hold the SETUP button ( ) for
three seconds.
For more details about the PROFILE
(operating profile) – refer to page 53.
Select the “limits” menu by pressing the
ENTER button ( ). Follow the on-
screen instructions to complete the
setup procedure.
Light
Light
Batt +
Batt -
MTR M+
MTR M -
MTR S+
MTR S -
Com
FRX
LIT
LED
Com
Aux 12V
Com Saf
Sol
open
FIGURE 52
FIGURE 53
FIGURE 54
FIGURE 55
Setting the limits