Installation manual

Page 22
FIGURE 24
FIGURE 25
4. Secure the bracket to the wall with the
most appropriate means.
It is critical that the wall bracket is
securely mounted.
See page 14 for site
considerations.
Determine the gate bracket position
One or two turns
5. Fit the gate bracket to the operator.
Start with the operator fully
retracted.
Turn out the actuator tube one or
two turns.
FIGURE 26
6. Fit the motor end of the operator to the
wall bracket.
7. Open the gate fully and temporarily clamp
the gate bracket to the gate.
The gate bracket must fit to a
sturdy point on the gate.
Consider using the optional gate
adaptor kit. See page 12
FIGURE 27