Installation manual

9. Operator installation
To simplify the installation process, it is recommended that the existing gate is
removed from the pillar before proceeding.
1. Determine gate opening angle and direction
of operator (inward or outward).
Alternatively the swing angle can be
determined more accurately with the
process detailed on page 31
120°
100°
110°
90°
80°
70°
60°
Open
Closed
Estimate
swing angle
2. Determine a suitable height for the wall
The gate bracket must fit to a sturdy
point on the gate.
Consider using the optional gate
adaptor kit.
Take care to make sure the operator
is mounted level.
Wall Bracket
85mm
Gate Bracket
Minimum 125mm
3. Determine where to put the bracket
according to A and B values in the tables on
pages 26, 27, 29 and 30.
B
A
120°
110°
100°
90°
80°
70°
60°
Gate opening angle
0°
120°
110°
100°
90°
80°
70°
60°
Gate opening angle
0°
Use Mechano kit
Cut the bracket
Operator must not
foul against bracket
Take care to shorten
the wall bracket to prevent
interference with the
operator
FIGURE 20. ESTIMATE SWING ANGLE
FIGURE 21. GATE HEIGHT
FIGURE 22. BRACKET POSITION
FIGURE 23. BRACKET POSITION
Page 21
Or