User guide

The gate will open approximately 1 metre and then stop. After 5 seconds the gate
will automatically close.
The gate can be held open by keeping the key turned in the keyswitch. As soon as
the key is released back to its normal rest position the gate will close after the 5
second delay. (The opening distance and the time that the gate remains open can be
adjusted to suit. Default values are described above)
If a protection beam has been fitted (refer section "Protection Beam") and the beam
is broken while the gate is closing, the gate will stop. The gate will remain in that
position while the beam is broken and only close 5 seconds after the beam has been
cleared.
Features and Functions
INTRODUCTION
The electronic controller synchronizes the functions of the gate operator. Although
the controllers for each operator are marginally different, the functions and safety
features which are described below are similar.
ANTI-CRUSHING DEVICE
Gate Closing
Gate closing onto an obstruction Gate automatically reverses and re-opens.
CENTURIONCENTURION
8 - Centurion Sliding Gate Operators User Guide