User guide

AUTOMATIC CLOSING(OPTIONAL)
The system has the facility to automatically close the gate after it has been opened.
The time that the gate remains open is adjustable up to 4 minutes.
AUTO-CLOSE OVERRIDE
The auto-close function can be temporarily overridden by holding down the remote
control pushbutton or intercom gate release when opening the gate, until the gate
stops. (Default setting is 3 seconds. It can be changed to suit) This confirms that the
auto-close has been overridden. On releasing the button the gate will continue to
open fully, and remain open as long as required. Closing the gate by using either the
transmitter or intercom gate release button resets the system back to auto-close.
If a gate status indicator (LED) has been fitted inside the house (refer below) an
additional confirmation of the functioning of the override is provided. The status LED
will stop flashing and remain ON when the auto-close has been overridden.
GATE STATUS INDICATION (OPTIONAL)
The controller can provide visual indication inside the house of the position of the
gate and the condition of the battery and power supply. A LED is typically mounted
on the intercom inside the house. The different
signals of the LED are described below.
- LED flashes slowly when gate is opening.
- LED flashes quickly when gate is closing.
- LED on if gate is open.
- LED off if gate is closed.
- LED flashes once every 2 seconds to indicate
that courtesy light is switched on permanently.
PRESS and HOLD
GATE RELEASE
FOR 3 SECONDS TO
OVERRIDE AUTO-CLOSE
INTERCOM PUSHBUTTON or REMOTE
GATE
STAYS
OPEN
CENTURIONCENTURION
10 - Centurion Sliding Gate Operators User Guide