Specifications

page 19
Features
and
functions
5.1.12. Intruder Detection Alarms* (a world first)
&
5.1.12.1. Ambush Alarm
Once activated, if the
opening or closing beams
are continuously interrupted
for a predefined time, the
Ambush Alarm will sound.
Intruders often cover beams’
lenses, thus breaking the
beam, so your gate stays
open after you have entered
or left your property – but
with the Ambush Alarm
enabled you can be instantly
alerted of any criminal
activity.
&
5.1.12.2. Break-In Alarm
If the closing beam on the
outside of your property is
broken, the Break-In Alarm
will sound and continue until
30 seconds have passed
since the beam is re-made.
Intruders will not be able to
loiter outside your property
as the Break-In Alarm will
immediately alert you of
their presence – and the
noise of the onboard buzzer
is often an effective
deterrent. Optionally the
alarm signal can be routed
to an armed response
company.
Intruder breaks safety beam
while loitering at gate, alarm
immediately activated for
30 seconds
If the Ambush Alarm or Break-In Alarm is utilised, the system may
be configured to operate one of the following outputs provided on
the controller:
&
Onboard buzzer – emits a continuous tone
&
Pillar / Courtesy light contact
&
Safety beam common
&
Status LED output
&
Auxiliary IO (which can be used to connect to a third party alarm
and security company, or a CENTURION G-Switch device to alert
you of the alarm via SMS)
It is typical to select only one of the alarm features.
* Requires infrared gate safety beams to be installed
FIGURE 26
FIGURE 27