Specifications

page 16
Features
and
functions
&
5.1.7.1. Emergency Stop
The Holiday Lockout
function can also be used as
an Emergency Stop
function. Mount an
emergency stop pushbutton
in a weatherproof housing
near the gate and you can
bring your gate to an
immediate stop with just
one press. The emergency
stop button must be reset
before the gate can be
operated again.
Emergency Stop will
override normal
Holiday Lockout Mode
functions.
If somebody tries to operate the gate via a valid access control
device, such as a remote control, etc. with Emergency Stop, the
onboard buzzer will beep periodically for 30 seconds to confirm that
the gate has been disabled using this feature.
The emergency stop is typically used at a manned entrance
so that security is not compromised with a would-be intruder
possibly gaining access to the stop button. In a domestic
situation you can set up one of your remote pushbuttons to
operate the emergency stop without compromising your
security.
5.1.8. Positive Close Mode
Positive Close Mode is intended for applications where the gate must
close fully against the gate end post for security reasons – such as
ensuring proper contact of the switch on the gate that feeds power to
the electric fence.
This feature operates only during the last few millimetres when the gate
closes.
It is recommended that a rubber strip be fixed to the front
edge of the gate to cut down the noise when the gate closes
against the end post.
5.1.9. Operator Run Profiles
The D5-Evo and D10 can be customised to your exact requirements
using your LCD controller. The open and closing speeds can be
independently set. Even the ramp up to full speed, ramp down to close
speed and crawl distance before the gate stops can be adjusted. Please
contact CENTURION for more information on finding the configuration
that is best for you.
FIGURE 21