Specifications

page 11
Features
and
functions
5.1.3. Automatic closing (Autoclose Mode)
The D5-Evo and the D10 sliding gate operators have the facility to
automatically close the gate after it has opened. When enabling this
feature, the time that the gate stays open is by default fifteen seconds
(this time is adjustable*)
As described in the previous section Autoclose is selectable with
Standard and Reversing Modes (page 9) and by default the function is
off. However, autoclose is automatically enabled in Condominium Mode.
We highly recommended that a safety beam is installed
across the gate entrance and connected to the Closing Safety
Beam input on the D5-Evo and the D10, if you enable
Autoclose Mode, in order to prevent the gate from closing on
people, pets or vehicles
* It is possible to adjust the delay before the gate closes in one second
increments from zero seconds to four minutes. The default time is five seconds.
&
5.1.3.1. Autoclose Override
Automatic closing can be
overridden in Standard and
Reversing Modes by pressing
and holding the button of the
remote control or intercom gate
release for no less than three
seconds. The gate response will
be to start opening and then to
stop as soon as the Autoclose
Override feature is activated.
On releasing the button, the
gate will continue opening until
fully open.
Your gate will stay open until
you use the remote control or
intercom gate release to close
the gate. The D5-Evo and the
D10 will then revert to normal
Autoclose operation
The Autoclose
function cannot be
overridden in
Condominium
Mode.
It is possible to adjust
the override time or
the time required to
FIGURE 12
Press and hold remote
control pushbutton;
gate will start to open
Gate stops to indicate
that Autoclose Override
has been engaged
Release pushbutton;
gate will continue to open
fully and stay open
hold down the button in order to override autoclose in
one second increments from one to ten seconds. The
default time is three seconds.