Installation guide

The pinion guard is
easily removed and
rotated allowing the rack
to be fitted above or
below the pinion.
8B.5. Use the orange height-
adjustment nuts
provided to level the
gearbox.
8B.6. Tighten the hold-down
nuts when the gearbox is
in the correct position.
Theft-resistant
nut and Discus
padlock are
available from
CENTURION for
sites requiring
additional
security.
Stud
locknut (M10 half-height nut)
Orange
height-
adjustment
nuts
Washer
Hold-
down
nuts
(M10
nuts)
Theft-
resistant
nut
Discus
padlock
Take care with the
orientation of the arrow
on the origin marker. This
arrow must face the
operator.
8B.7. Mount gate origin
marker to rack as per
illustration C, D and E,
with the gate in the
closed position.
8B.8. Battery is fitted between
the motor enclosure
unit and the D2 Turbo
controller.
8B.9. Unclip the orange clips
holding the controller
onto the motor enclosure
unit.
8B.10. Fit the 7.2Ah/5Ah
battery and clip the
orange clips down to
secure the battery in
place.
Unclip
orange
battery
clip
Clip
orange
battery
clip to
secure
Fit the
7Ah/5Ah
battery
Origin sensor
inside motor
enclosure
Origin
marker
TurboTurbo
10-17mm
Gate
Rack
E: Plan view
Greater than 500mm
Gate in
closed
position
TurboTurbo
D: Plan view
Origin
marker
Greater than 500mm
C: Isometric view