Installation guide

This guide is designed specifically for installers who are familiar with the
installation of standard sliding gate motors, but do not know the specifics
of the D2 Turbo.
The D2 Turbo domestic sliding gate operator has been designed solely to
open and close domestic sliding gates. It must not be installed or used to
automate the entrances of townhouse complexes, housing estates,
industrial sites, etc.
It is a 12V DC battery operated unit with the following limitations:
Gate mass maximum: 250kg
Starting pull force: < 18kgf
Rated running force: < 9kgf
Maximum speed: 24 metres/minute
Maximum gate length: 10 metres
Design life: Ten years at ten cycles per day
Please do not proceed with the installation until you have
read and fully understand the Safety instructions included in
your product packaging. The Safety instructions are also
available on www.centsys.co.za, and may also be obtained
by contacting Centurion Systems on [phone]
(SA only).
This icon denotes variations and other aspects that should be
considered during installation.
This icon indicates tips and other information that could be useful
during the installation.
This icon indicates a warning, caution or attention!
Please take special note of critical aspects that MUST be
adhered to in order to prevent injury.
3
9
Which bit is what?
1. Motor fuse
2. Motor enclosure unit
3. Camlock cover
4. Release thumbwheel
5. Foundation plate
6. D2 Turbo controller
1
7. 12V 7.2Ah or 5Ah battery
8. Battery strap
9. Pulley guard
10. Gate mounted origin marker
11. Origin marker bracket
2
5
7
6
10
11
4
8