Instruction manual

26 27
Return To Factory Default Settings
Replacing a lost Programming Code
Warning:
You must be very careful before using this command! Doing so will erase the entire memory
which includes all User and Special Codes, and return all codes to their factory default
settings.
1)EnterProgrammingMode
2)Press“0”toenterMenu 0
 •TheModeLEDwillashred
 •TheDoorLEDwillashred
3)Enterthe4-digitProgrammingCode.
 •IftheProgrammingCodeisvalid,allmemorywillbeerased,youwillhear3beepsand
 thecontrollerwillreturntoNormalMode
 •IftheProgrammingCodeisinvalidyouwillhearalongbeepandthecontrollerwill
 returntoNormalModewithouterasingthememoryofthecontroller.
Note : TheSA1DKmustbeinNormalModeotherwisethiswillnotwork.MakesurethattheMode
LEDisgreenbeforeproceeding.
1)RemovepowerfromtheSA1DK
2)PresstheREXbutton
3)ApplypowertotheunitwithREXbuttonpressed
4)ReleasetheREXbutton
5)Younowhave15secondstoprogramanewProgrammingCodeintotheunitusingtheinitial
defaultcode1234,beforethecontrollerrevertstotheexistingcode.
Replacing a lost Programming Code
Note : TheSA1DKmustbeinSecureModeotherwisethiswillnotwork.MakesurethattheMode
LEDisredbeforeproceeding.
1)RemovepowerfromtheSA1DK
2)PresstheREXbutton
3)ApplypowertotheunitwithREXbuttonpressed
4)ReleasetheREXbutton
5)Younowhave15secondstoprogramanewNormal/SecureCodeintotheunitusingtheinitial
defaultcode3838,beforethecontrollerrevertstotheexistingcode.