Instruction manual

9. The Request to Exit (REX) Button

10. Case and Back Tamper

8.4 Changing from Bypass Mode to Normal Mode

For the Bypass Mode, the Mode LED is orange

See Changing the Normal/Bypass Code and Door Chime Settings

to create/modify the Normal/Bypass Code.

1. Enter the 4-digit Normal/Bypass Code.

ModeLEDashesgreen.

2.Pressthe#keytoconrmthemodechange.

Mode LED turns green.

The REX button is used to open the door without the use of a proximity card or PIN code, and must

be located inside the premises in order to be secured. IT is usually located in a convenient location,

such as inside the door or at a receptionist’s desk. The function of the REX button depends on

whether the Lock Strike Relay is programmed for Fail Safe Operation or for Fail Secure Operation.

The door chime in the BL-D40 does not sound when the REX button is used to open the door.

 •FailSecureOperation:FromthemomenttheREXbuttonispressed,thedoorremains

unlocked until the “Lock Strike Release Time” has passed. After this time, the door is

locked even if the REX button has not been released.

 •FailSafeOperation:FromthemomenttheREXbuttonispressed,thedoorremains

unlocked until the REX button is released and the “Lock Strike Relay” only begins its

countdown once the REX button has been released.

If the case of the controller is opened or the controller is removed from the wall, a tamper event is

triggered and a coded tamper signal is sent to a BL-D40, PS-X41 Series or PS-X42 Series Power

Supply, or to another compatible device.

If the BL-D40 External Sounder, PS-X41 Series, or PS-X42 Series Power Supplies receives a Tamper

Event Signal, it activates a Siren, and if available, a Strobe Light. The Siren time can be easily

programmedintheSA1DPfromzerotonineminutes.

YoucanclearatampereventbyenteringavalidUserorOpenCodetoopentheLockStrikeOutput

in the current Mode of Operation. For example, while in Secure Mode, you cannot use the Open

Codetoclearthetamperevent,becausetheOpenCodedoesnotworkinSecureMode.However,

you can apply a Master Code or Secure Code to clear the tamper event in Secure Mode.