Instruction manual

4
The following are some of the SA1DP key features :
 •Built-inProximityCardReader(125KHzASKModulation)
 •Built-inKeypadforPINcodeentry
 •InternalBuzzer
 •Comeswithsecurityscrewandsecurityscrewtool
 •TwoStatus/ProgrammingInterfaceLEDs
 •ThreeUserLevels(NormalUser,Secureuser,MasterUser)
 •ThreeModesofOperation(NormalMode,BypassMode,SecureMode)
 •”CodeSearch”featuresimpliesmaintainingusercodes
 •InputforRequesttoExit(REX)button
 •LockStrikeElectronicRelaywithbuilt-insuppressorprotection
 •Comeswithmountingtemplateforeasierinstallation
 •Built-inCaseandBackTamper
 •Bell,Chime,Siren,andStrobefeaturesavailablewithBL-D40
 •ProgrammableSirenTime
 •ProgrammableLockStrikeReleaseTime
 •ComeswithSuppressionDiode(1N4004)
4.1 Mounting
TheSA1DPisdesignedtobeeasilymountedontoaUSGangBox.
1. Before starting, select the location to mount the SA1DP controller. This location should be at
shoulder height and on the same side as the door handle.
2.RemovetheBezelScrewfromtheSA1DP(seeFigure1).
3.ScrewtheSA1DPcontrollerontoaUSGangBoxthroughthe2MountingHolesprovided(see
gure2).
4. Pass the wires through the exit/entry holes and attach them to the controller’s terminal blocks, as
shown in the wiring diagrams. (See Figure 3 & 4 in Wiring Diagrams for wiring diagrams of
common installations).
5.Replacethecontroller’sbezel,andreplacethefactorydefaultscrewwiththesecurityscrewthat
isprovidedintheInstallationKit.AsecurityscrewtoolisalsoprovidedintheInstallationKit.
3. Key Features
4. Installation