Instruction manual

3
The SA1DP is a proximity card and keypad access control unit. The unit accepts up to 500 users
and provides entry via the use of proximity cards and/ or PIN codes.
1.1 Equipment
The following equipment is provided in every SA1DP package :
  •SA1DPAccessControlUnit
  •InstallationKit
  •InstallationandOperatingInstructions
1.2 Additional Equipment
The following additional equipment is required :
•Electric Lock Strike Mechanism - Fail Safe (Power to Lock) or Fail Secure
(Power to Open)
•Power Supply with Backup Battery - 12 to 16 V DC (from a regulated power
supply)
•Request to Exit (REX) button - Normally Open Type; Switch is closed when
pressed
•BL-40 External Sounder (optional) - Provides siren, bell, and chime function
to SA1DP
Electrical Characteristics
Operating Voltage Range 12-16VDC
From a regulated power supply
Input Current Standby : 40mA (excluding attached devices)
Max : 90mA (excluding attached devices)
Relay Outputs Lock Strike Relay - Electronic, 3.5A with built-in suppressor
protection
Inputs REX - N.O., Dry Contact
LEDs Two tri-colored LEDs
Built-in Proximity Reader Read Range* - 3.5” (90mm)
   Modulation-ASKat125kHz
Compatible Cards - All 26-Bit EM Cards
Environmental Characteristics
Operating Temperature -25°F to 145°F (-31°C to 63°C)
Operating Humidity 0 to 95% (Non-Condensing)
Dimensions 3.62” (92mm) L x 3.62” (92mm) W x 0.94” (24mm) D
Weight 0.29 lbs (130g)
1. Introduction
2. Technical Specications