Instruction manual

19
12.11 Return to Factory Default Settings
WARNING!! Be very careful before using this command as it will erase the entire memory,
including all User and Special Codes, and will return all codes to their factory default settings.
1. Enter Programming Mode.
2. Press “0” to enter Menu 0.
TheModeLEDandtheDoorLEDashred.
3. Enter your 4-digit Programming Code.
If the Programming Code is valid, all memory
is erased, 3 beeps are emitted, and the controller
returns to Normal Mode.
 •IftheProgrammingCodeisinvalid,along
beep is emitted, and the controller returns
to Normal Mode without erasing the memory
of the controller.
12.12 Replacing a Lost Programming Code
Note : In order to be able to replace a lost programming code, the SA1DP must be in Normal
Mode. Before proceeding, verify that the Mode LED is green.
1. Remove power from the SA1DP
2. Press the REX button.
3. Apply power to the unit while pressing the REX button.
4. Release the REX button.
5. Program a new Programming Code into the unit using the initial default code 1234. You have 15
seconds to do so, before the controller reverts to the existing code.
12.13 Replacing a Lost Normal/Secure Code
Note : In order to be able to replace a lost Normal/Secure code, the SA1DP must be in Secure
Mode. Before proceeding, verify that the Mode LED is red.
1. Remove power from the SA1DP
2. Press the REX button.
3. Apply power to the unit while pressing the REX button.
4. Release the REX button.
5. Program a new Normal/Secure Code into the unit using the initial default code 3838. You have 15
seconds to do so, before the controller reverts to the existing code.