Instruction manual

16
12.9.4 Enrolling Primary and Secondary Codes using the Standard Method
1. Enter Programming Mode.
2. Press “7” to enter Menu 7.
The Door LED turns orange.
3.Enter3-digitUserSlotnumberbetween001to500
to indicate the user to who you want to enroll a
Primary or Secondary code.
Forexample,theUserSlot003representsUser#3.
 •IftheselectedslotdoesnothaveaPrimary
 Code,theModeLEDashesgreen,indicating
that the controller is ready to accept a Primary
Code.
 •IftheselectedslotalreadyhasaPrimaryCode
but does not have a Secondary Code, the Mode
 LEDashesred,indicatingthatthecontrolleris
ready to accept a Secondary Code.
 •IftheselectedslotalreadyhasaPrimaryand
Secondary Code, a long beep is emitted and
the controller returns to Normal Mode.
4. Present a proximity Card, or enter 4-digit PIN that you
want to assign as the Primary or Secondary Code for
this slot number.
5. If the Proximity Card or PIN that is entered is valid, the
ModeLEDstopsashingandthecontrollerisnowready.
You can either continue or stop enrolling codes.
 •Toenrollacode,enterthenext3-digitslotnumber
that you want to assign a code to, or press the # key
to move to the next slot number.
 •Tostopenrollingcodes,pressthe#keyfortwo
seconds to return the controller to Normal Mode.