Instruction manual

12
12.3 Changing Open Code 1
Open Code 1 is mainly used as a method to quickly test the Lock Strike Relay during installation.
The Default Factory Setting for Open Code 1 is 2580.
Whentherstuseisaddedtothecontroller,thedefaultOpenCodeisautomaticallydeleted,and
is ready for a new Open Code 1 to be reentered.
1. Enter Programming Mode.
2. Press “1” to enter Menu 1.
The Mode LED turns red.
3. Enter the new 4-digit code that you want to set as Open Code 1.
 •TheDoorLEDturnsoff.
 •TheModeLEDturnsgreen.
Note : Open Code 1 does not function is Secure Mode.
Wrong entries return the controller to Normal Mode.
Code 0000 erases and deactivates the Open Code.
12.4 Changing Open Code 2
Open Code 2 is mainly used as a method to quickly test the Lock Strike Relay during installation.
The Default Factory Setting for Open Code 1 is 0852.
Whentherstuseisaddedtothecontroller,thedefaultOpenCodeisautomaticallydeleted,and
is ready for a new Open Code 2 to be reentered.
1. Enter Programming Mode.
2. Press “2” to enter Menu 2.
The Mode LED turns orange.
3. Enter the new 4-digit code that you want to set as Open Code 2.
The system returns to Normal Mode :
 •3beepsareemitted.
 •TheDoorLEDturnsoff.
 •TheModeLEDturnsgreen.
Note : Open Code 2 does not function is Secure Mode.
Wrong entries return the controller to Normal Mode.
Code 0000 erases and deactivates the Open Code.