User Manual

If you are having problems positioning it, try reading our help on positioning.
I can't see a flashing light on it
When the Button flashes its light, the whole of the orange ring on the front will light up!
When you first put the battery in, you should expect to see the Button light blink twice every few seconds; the
light will go out once the Button is communicating with the Hub. The light will come on again when this Button
is selected for placement on the website; then, it will flash regularly once a second (if it is in a good position for
the Accessory to be installed), or it will blink twice every few seconds (if it is not in a good position). If you
aren't placing this Button, it most likely will not be flashing its light.
How do I stick it up?
Firstly, make sure you know how to use the sticky pads! If you haven't already read the instructions for these,
do so now here.
Peel a sticky pad off the backing sheet, put it onto the back of the Button and press firmly for a few seconds.
Then, peel off the printed part of the cover sheet off the pad you just stuck down, and press the Button against
the surface you want to stick it to firmly for a few seconds. Done!
With the Button, you have the alternative of using screws to fix the Button to a wall. There are special guide
circles on the back part of the Button where you could punch through in order to use screws; these should be
obvious if you lift off the front of the Button as if you were changing the battery. Screw the back plate onto
your wall, then simply clip the front part back on.
What does the flashing light mean whilst I'm installing it?
When this Button is selected for placement on the website it will flash regularly once a second (whilst it is in a
good position for the Accessory to be installed), or it will blink twice every few seconds (if it is not in a good
position).
You should hold the Button still in the place you want to install it for about 5 seconds. If the light flashes
regularly once a second all that time, it is a good spot to install it. If it doesn't, you should try moving the
Button somewhat - read our tips here.
I can't get it to flash regularly where I want to install it
Check you have followed our Accessory positioning guidelines. For help with getting Accessories to
communicate with your Hub all around your home, click here.
What does the flashing light mean when I'm testing it?
Once you have installed your Button, the light will go out for the remainder of the Alertme setup process.
When you reach the testing stage, the light will come on whenever the Button is pressed. For more
information about testing, click here.